Skip to main content

Netskope Help

Enable Auth Proxy Mode

You must enable the Auth Proxy.

To enable the Auth Proxy:

  1. Enter the command: 

    set dataplane auth-proxy enable true

    Important

    Saving the configuration is required to enable the Auth Proxy.

  2. Once the interface is set, run the following command to initiate a health check: 

    set healthcheck enable true

  3. Enter the save command, and then press Enter.

You have now completed the installation and configuration of the Auth Proxy. Auth Proxy will make an initial connection to the Netskope cloud.

In this section: