Skip to main content

Netskope Help

Configure the Dataplane On-Premises (DPoP) Appliance

The appliance can act as a proxy server in your network when configured as a Dataplane On-Premises Appliance. The appliance processes requests from client machines and sends the event logs to the Netskope cloud.

Configuring the appliance as a Dataplane On-Premises Appliance involves the following steps:

You must first set the license key and point the device to the Netskope cloud. Follow these steps:

  1. Connect to the appliance console.

  2. Log into the console using the credentials nsadmin/nsappliance. Your prompt will change to the Netskope shell prompt, nsappliance.

    Note

    You can change your password by using the command, auth change-password nsadmin.

  3. At the nsappliance> prompt, enter configure to go to configuration mode.

  4. Get your license key from your Netskope tenant UI (Settings > Security Cloud Platform > On-Premises Infrastructure), and then enter this command to set the license key:

    set system licensekey <licensekey>
  5. Set the DNS server IP address by entering this command:

    set dns primary <dns server IP address>
  6. Enter save to save the configuration.