Skip to main content

Netskope Help

Fixed Issues for Virtual Appliance Version 99.0.0

The following fixed issues are included in this release.

Issue Number

Issue

Description

176981

If you have configured an auth proxy in your network using a Virtual appliance or a Physical Appliance with the option Enable Direct Authentication for Managed Devices enabled, and have the Netskope Client, then you will be prompted to login twice when connecting to a website.

Fixed.

215559

1. Multiple IP addresses were not allowed to be configured in the Virtual Appliance.

2. The correct inbound interface was broken because it was not parsing new interface configuration schema correctly.

1. IP addresses separated by a "," now works.

2. Due to the addition of "v4" in the interface configuration dictionary, the inferring inbound interface for the Virtual Appliance broke

213087

Importing Appliance configuration in default mode does not work. However, importing Appliance configuration "without-network" does work.

Configure the network configuration on the new virtual appliance and import configuration "without-network".

177566

Resetting the configuration does not reinsert the dns settings.

After resetting the configuration, apply dns settings in this configuration:

  • reset_non_networking_config

215559

CLI not accepting IP list for VA interfaces.

Multiple IP addresses were not allowed to be configured in VA because of incorrect use of IP address validator which worked only for single IP address. Logic to infer correct inbound interface was broken because it was not parsing new interface config schema correctly.