Skip to main content

Netskope Help

Configure the Auth Proxy

Configuring the Auth Proxy involves configuring the interface, system, and DNS server.

To configure the Auth Proxy:

  1. Power up the Auth Proxy and open the console view.

  2. Log into the Auth Proxy using the credentials nsadmin/nsappliance.

    Note

    You can change your password by using the CLI command, auth change-password nsadmin.

  3. When you first log in, you will be dropped into the system shell. To configure the Auth Proxy you need to access the Netskope shell. Type nsshell at the command prompt. Your prompt should change to sforwarder>.

  4. At the sforwarder> prompt, enter configure to go to configuration mode.

In this section: