Configuring your Netskope Active and Passive Auth and MEX URLs
To configure your Netskope Active Auth, Passive Auth, and MEX URLs:
Use Powershell to log in to your cloud O365 instance, and then enter
$cred=Get-Credential
.Enter your admin credentials.
Enter
Connect-MsolService -Credential $cred
.Depending on your auth mode, enter one of these commands:
Netskope_Passive_URL:
$Netskope_Passive_URL = <Netskope Passive Auth URL from the Netskope UI>
Tip
To use an endpoint URL for passive auth, refer to Configuring Passive Auth with an Endpoint URL.
Netskope_Active_URL:
$Netskope_Active_URL = <Netskope Active Auth URL from the Netskope UI>
Netskope_Federation_Metadata_URL:
$Netskope_Federation_Metadata_URL = <Netskope Federation Metadata URL from the Netskope UI>
Enter your domain name:
$dom = <domain name>
.Update the Federation Settings:
Set-MsolDomainFederationSettings -DomainName $dom -PassiveLogOnUri $Netskope_Passive_URL -LogOffUri $Netskope_Passive_URL - ActiveLogOnUri $Netskope_Active_URL -MetadataExchangeUri $Netskope_Federation_Metadata_URL
Note
Netskope_Passive_URL, Netskope_Active_URL, and Netskope_Federation_Metadata_URL are generated URLs in the Netskope Admin UI.